Skip-Line SC-12 - Page 26


Note that not all modes are available on all systems.
4.3.2 Bead Guns
The Bead Guns  option enables and disables bead guns from engaging during
striping operation.
4.3.3 AutoCycle
AutoCycle  causes the cycle to change +/- 0.1'after the Advance/Retard switch
has been pressed in the same direction three times. This assists with correcting
the cycle to match previous markings during rework operations.
4.3.4 Midspot
Midspot  adds a dot in the middle between the end of one stripe and the start of
the next. Midspot can occur every cycle, or every other cycle with a ½  midspot
setting. The ½ Odd  setting adds the midspot on odd cycles (1
st
, 3
rd
, etc.) while
the ½ Even  settings adds the midspot on even cycles (2
nd
, 4
th
, etc.).
Midspot length is determined by the Dot Length parameter in the Marker Layout
menu.
4.3.5 Index
This setting allows the skip timer to start the pattern on either the stripe or the
gap when the START switch is engaged.
4.4 Counter Channel Menu
The Counter Channel  menu provides access to distance and volume usage
counters. Clearing the counter channels is common at the beginning of a new
job.


SC-12 Road Marking Control System - Installation and Operation Manual   26
