A short circuit has been detected on an
output pin. Remove the short circuit, and
clear the error to resume use of this pin.
Turn Run switch to Hold to continue.
On systems with a
RUN-HOLD
switch, the
switch must be in the
HOLD
position before
operations can begin after system
power-on. This prevents inadvertently
engaging material at power-on.
Turn off Start switch to continue.
On systems with a
START-STOP
switch, the
switch must be in the
STOP
position before
operations can begin after system
power-on. This prevents inadvertently
engaging material at power-on.
Flash image mismatch: update image via
USB.
Images and audio files for the program do
not match the main program installed on
the system.
➢
Insert a USB drive with the correct
update file.
➢
Contact Skip-Line for support.
Flash memory unreadable.
The flash memory that contains graphics,
audio files, and logged counter channel
records is not communicating.
➢
Contact Skip-Line for support.
Duplicate switch detected. Fix and cycle
power.
A switch with the same function is
connected via the CAN expansion port, or
devices with incompatible programs are
both on the same system.
➢
Remove other devices from the CAN
bus.
➢
A full system power cycle is required
to clear this error.
➢
Contact Skip-Line for support.
No communication with Core
Skipper.
The SC-12 master boxes must be able to
communicate with the Core Skipper device
in order to operate, since the Core Skipper
is the central computer for the system.
SC-12 Road Marking Control System - Installation and Operation Manual
60
To Next Page
Loading...
