➢
If the message is cleared, the critical
error message will reappear in two
minutes if the problem still exists.
Core Skipper is initializing...
This appears on startup to indicate that the
system is not quite ready for operations yet.
It will disappear once the system is ready.
Gun #X Disabled - Change color from
'None' to fix.
Guns can be disabled by setting the color to
None
. If the color is set to none, but the
switch is not in the
OFF
position, this
message reminds the operator of the gun's
current status.
➢
If the gun is intended to be used,
change the gun color from
None
to
the correct color in the Gun Setup
menu.
➢
If the gun is not intended to be in
use, move the pattern switch to
OFF
.
Attached USB device has an error.
The system has detected a USB device is
plugged in, but can't determine what kind
of device it is.
➢
Remove the device from the USB
port.
➢
If the device was a USB flash drive, it
is not compatible— try a different
USB drive.
Attached USB device is not a flash drive.
The system has detected a USB device is
plugged in, but that device is not a flash
drive.
➢
Only USB flash drives are compatible
with this USB port —unplug any
other devices.
➢
If the device was a USB flash drive, it
is not compatible— try a different
USB drive.
SC-12 Road Marking Control System - Installation and Operation Manual
59
To Next Page
Loading...
