Operation and Installation CD401MR-SC
Date: 2022-09-26Page 30 of 48
CHAPTER 4. Maintenance
_____________________________________________________________________
No maintenance is required. The screen can be cleaned with a soft cloth.
If the info screen is activated on the run screens, the system type and rmware version
can be read from there. Otherwise the same screen can be obtained in the diagnostics
menu. The system type will be one of the following:
CD401E1 Compact display EML 1 Axis.
CD401E2 Compact display EML 2 Axis.
CD401EB Compact display EML 2 Axis backwards.
CD401LR Compact display Log Repeater.
CD401MR Compact display Multi Repeater.
CD401MB Compact display Multi Repeater backwards.
The system will be locked to one of these setups, but can be changed to one of the other
systems (with an additional cost) using a code (see Appendix 3).
The system is undergoing continuously improvements, and periodically new rmware
will be released. A chip can be supplied (with an additional cost) with the new
software. This is changed by removing the backplate of the Compact display.
The Compact Display could also be set up to operate in ”Multi Repeater, Backwards”
mode. In this mode all speeds are in opposite direction. See Appendix 3 on how to
change the system setup. The parameters in ”Multi Repeater, Backwards” mode will be
replaced according to the following:
STWWL = - STWWL SOGBL = - SOGBL
STWWT = - STWWA SOGBT = - SOGBA
STWWA = - STWWT SOGBA = - SOGBT
To Next Page
Loading...