Skipper SB-100-SB User Manual

SKIPPER Electronics AS
Enebakkveien 150
P. O. Box 151, Manglerud
0612 Oslo, Norway
www.skipper.no
Telephone: +47 23 30 22 70
E-mail: support@skipper.no
Document no: DM-BSB100 Rev 2012
Edition: 12.08.2020
100mm
Single bottom sea valve
Installation and operation Manual
SB-100-SA
SB-100-SB

Skipper SB-100-SB Specifications

General

Brand	Skipper
Model	SB-100-SB
Category	Control Unit
Language	English

Summary

1. Introduction

2. Space Considerations

3. Welding the Bottom Flange

4. Sea Valve Assembly

Assembly SB-100-SA

Step-by-step guide for assembling the SB-100-SA model, detailing part placement and tightening procedures.

Assembly SB-100-SB

Step-by-step guide for assembling the SB-100-SB model, detailing part placement and tightening procedures.

5. Assembling Extension Tube and Sensor

6. Sensor Installation

7. Clamp Unit Mounting

8. Lower the Sensor

Lowering Sensor in SB-100-SB

Procedure for lowering the sensor in the SB-100-SB model, including marking for correct depth.

Lowering Sensor in SB-100-SA

Procedure for lowering the sensor in the SB-100-SA model, including marking for correct depth.

9. Sensor Forward Orientation

10. Final Assembly

11. Sensor Removal

12. Re-installation

13. Illustrated Parts List (Shipment)

14. Illustrated Parts List (Assembled)

15. Maintenance

Maintenance Tasks for Inactive Sensors

Procedures for maintaining sensors when the system is off for extended periods, including closing and restarting steps.

Dry Docking in Temperatures Below Freezing Point

Warning regarding potential damage to sea valve or transducer if water remains inside during dry docking in freezing temperatures.