Skipper SB-100-SB - 4. Sea Valve Assembly; Assembly SB-100-SA

Page9 of 22
Date: 12.08.2020
4. SEA VALVE ASSEMBLY.
• Place 1.5 mm gasket, Item (18) on top of Bottom Flange, Item (1).
• Then place the Main element, Item (6) on top of the Bottom Flange. The 16 mm nuts and washers should
be mounted and tightened. (Align parts before tighten nuts).
• Place a 1.5 mm gasket (item 18) on top of the main element, Item (6).
• Mount the intermediate element, Item (15) on top of the main element.
• All 8 screws, nuts and washers should be mounted, and tightened. (Align parts before tighten nuts).
Assembly SB-100-SA
Caution must be taken when mounting seavalves that all parts are aligned correctly, and that the inside is
clean. DO NOT use liguid sealants, and DO NOT paint the inside of a valve.
SKIPPER Electronics AS
SB-100-XX Operation and Installation Manual