Skipper SB-100-SB - 8. Lower the Sensor; Lowering Sensor in SB-100-SB; Lowering Sensor in SB-100-SA

Page14 of 22
Date: 12.08.2020
8. LOWER THE SENSOR
• To ensure sensor is properly inserted completly into the bottom ange make a distance mark to indicate
when the sensor is at bottom.
• SB-100-SB/SB-100-LB distance from top of ball to bottom: 234mm
• SB-100-SA/SB-100-LA distance from top of gate to bottom: 180mm
• Before opening the sea valve. Lift up the sensor some cm to avoid scratches when valve opens.
• Open Sea Valve, lower sensor unit and Extension Tube.
180mm
Lowering sensor in SB-100-SA
Lowering sensor in SB-100-SB
SKIPPER Electronics AS
SB-100-XX Operation and Installation Manual