Operation overview
Fig. 292 Operating lever
Read and observe on page 233 first.
Overview of ACC functions operated with the lever » Fig. 292
1
Activate ACC (regulation deactivated)
2
Start control (resume) / increase speed by 1 km/h at a time
(sprung position)
3
Interrupt control (sprung position)
4
Deactivate ACC
5
Increase speed by 10 km/h at a time
6
Decrease speed by 10 km/h at a time
A
Set proximity level
B
Start control / reduce speed in increments of 1 km/h
If the lever is set from the position directly into the sprung position
the current speed is stored and the control process is started.
Start control
Read and observe on page 233 first.
Basic requirements for start of control
The ACC is activated.
On vehicles with manual transmission, the second gear or a higher gear is
selected and the current speed is greater than 30 km/h.
On vehicles with automatic transmission, the selector lever is in the D/S
position or in the Tiptronic position.
Start control
›
Press the button » Fig. 292 on page 235 .
›
Or: set the lever into the sprung position » Fig. 292 on page 235 .
The ACC takes the current driving speed and performs the control, the warn-
ing light
illuminates in the instrument cluster.
If the control is started by moving the lever to the position
and if the
speed is already stored, the ACC adopts this speed and carries out the control.
Note
If control is started at a speed of less than 30 km/h on vehicles with an auto-
matic transmission, the speed of 30 km/h is stored. The speed increases auto-
matically to 30 km/h or is regulated with respect to the speed of the vehicle
ahead.
Stop/resume control
Read and observe on page 233 first.
Stop control
›
Set the lever into the sprung position » Fig. 292 on page 235 .
›
Or: apply the brake.
Control stops, the speed remains stored.
Resume control
›
Start control » page 235, Start control.
Note
Control is also stopped when the clutch pedal is held down for longer than 30
s or the TCS is deactivated.
235
Assist systems
To Next Page
Loading...
