22
Security diode
Activating the electronic security
system
Press the TP button
ß?
to display the
Setup menu.
• Select the "CODE/SAFE" function.
• Press
Ń or Ľ of the rocker
ß`
.
• "1– – – –" appears in the display.
• Use the station buttons
ßR
to enter the
code number which is to be found on the
radio card.
Briefly press the station button 1 to
enter the first digit of the code number,
then station button 2 for the second
digit, etc.
• When this is done, press for more than 2
seconds on
ľľ or ıı of the rocker
ß`
then release the pressure.
• If you have entered the correct code,
“SAFE” will be displayed after a few
moments.
The car radio is locked again.
THEFT PROTECTION CODING
The security diode
ßU
flashes if the radio
is switched off and the ignition key is
removed.
›
19
Incorrect code number
If you enter an incorrect code number
when attempting to deactivate the electro-
nic security system, "SAFE" appears after
about 10 seconds and then “2 – – – –”
(2nd attempt) in the display.
You may then repeat once the entire
operation. The number of attempts is
indicated in the display.
If you enter an incorrect code number
again, the radio will be locked for the
waiting times indicated in the table below.
Waiting times between attempts:
Attempt Waiting time
(display) (approximately)
1 10 sec.
2 1.5 min.
3 5 min.
4 21 min.
5 1.5 hrs.
6 6 hrs.
7 24 hrs.
8 24 hrs.
To Next Page
Loading...
