sks BSV2012 - Disassembly Instructions

SKS-Kinkel Elektronik GmbH
10006901 BSV2012 Video indoor station hands-free
EN
Support Hotline: +49 (0) 2661 98088-112
Support E-Mail: support@sks-kinkel.de
Version No. 2.0
Document No. 97010703
44
Connect the terminals to the previously installed cable. The ter-
minals are located at the back of the BS2012 video indoor station
hands-free.
To avoid errors when connecting cables please use the plan-
ning guide or the wiring diagram.
Set the SKS BUS call address at the DIP switch on the back of
the BS2012 video indoor station hands-free. Each address is as-
signed to a bell button at the door station. The SKS BUS table of
call addresses can be found in the appendix.
Pay particular attention to the setting of the DIP switch when
the BS2012 video indoor station hands-free is replaced!
Remount the BS2012 video indoor station hands-free in the upper
part of the supporting frame.
Subsequently press the indoor station onto the frame until it clicks
into place.
When joining the indoor station and its frame both parts must
match exactly, so that the contacts on the frame t properly into
the terminals of the indoor station.
7.4 Disassembly
Open the BS2012 video indoor station hands-free as described in chapter “Preparation” and remove it from the sup-
port frame. Remove the terminal plugs from the indoor station and if necessary the support frame by unscrewing it.