sks BSV2012 - Initial Setup and Configuration; Setting Call Address; Programming Call Addresses

45
Support Hotline: +49 (0) 2661 98088-112
Support E-Mail: support@sks-kinkel.de
Version No. 2.0
Document No. 97010703
SKS-Kinkel Elektronik GmbH
10006901 BSV2012 Video indoor station hands-free
EN
8 Initial setup
8.1 Setting of call address (i. e. one call button for one indoor station)
Please set the call address needed at the device’s DIP switch according to the SKS call ad-
dress table (s. appendix). Each call address is assigned to one call button at the door station.
For the BS2012 video hands-free the main call address is always set at the DIP switch
at the back of the device.
8.2 Programming of call addresses
Programming call addresses is necessary only when internal or group calls are to be set up.
8.3 Programming of call addresses (i. e. two to five bell buttons for an indoor station)
If more than one bell button is assigned to one indoor station, all the relevant call addresses (apart from the main call
address) need to be programmed into the indoor station.
To program up to four more call addresses follow these steps:
Step Description
1
If unsure whether any or which call addresses have al-
ready been programmed pick the menu point → Setup
→ Own address to check which call addresses have
been programmed in the device.
As default no additional call addresses are programmed.
2 Set the main call address (= 1
st position in your storage space) at the DIP switch, this reacts
to the respective bell button of the door station. This rst and main call address is visible only
at the DIP switch and is not shown in the menu.
Programming button
DIP switch