sks HTV4600 User Manual

SKS-Kinkel Elektronik GmbH
Indoor station HTV4600, Receiver, 6-wire
EN
Support Hotline: +49 (0) 2661 98088-112
Support E-Mail: support@sks-kinkel.de
Version No. 3.0
Document No. 97003704
44
Touch key Function Description
VID
+
Change ringtone of
calls from the door sta-
tion
The ringtone of calls coming from the door station is the one
initiated by someone ringing the doorbell.
To change this ringtone start by holding the tone key and addi-
tionally tap on the door opener key, so that the actual ringtone
is played. Tapping the door opener key again another ringtone
will be played – all in all there are eight ringtones to choose
from. To pick a respective ringtone let go of both keys while it is
played. The ringtone will now be set as standard.
VID
+
Change ringtone of
calls from the oor sta-
tion
The ringtone of calls coming from the oor door station is the
one initiated by someone ringing the bell on your oor door.
To change this ringtone start by holding the tone key and
additionally also hold the door opener key, so that the actu-
al ringtone is played. If you keep hold of both keys another
ringtone will be played – all in all there are four ringtones to
choose from. To pick a respective ringtone let go of both keys
while it is played. The ringtone will now be set as standard.
VID
Change ringtone volume
To change the ringtone volume keep hold of the tone key so
that signal tones are played at the actual volume. If you keep
hold of the key, the volume is lowered step by step.
There are ve steps, if the lowest step is exceeded, the loud-
est one will be played again. To pick a step, let go of the key
at the volume you prefer to set it as standard.
S
Special functions
(Only possible with an ad-
ditional switching actor or
BUS actuator module!)
The special key „S“ is usually used for switching with the help
of an additional switching actor or BUS actuator module, i. e.
for opening a oor door or to call the concierge.
If the function is activated and assigned to this key, push the
„S“ key and keep hold of it until you hear a signal tone to carry
out the function.
Switch on light
(Only possible with an ad-
ditional switching actor or
BUS actuator module!)
The light key is usually used for switching with the help of an
additional switching actor or BUS actuator module. By push-
ing the light key a command is sent to the BUS, which can be
used for switching by an actor.
If the function is activated and assigned to this key, push the
light key to switch on the light. A signal tone conrms that the
function has been performed successfully.
1
bis
5
Internal call
(Only possible with the
11-key version of the
HTV4600 (item 100039)!)
Here you can set up up to ve internal call addresses.
To send out an internal (or group) call hit the respective button.
A signal tone is played and the respective indoor station, saved
on this button, is called.
For programming internal call addresses please contact your
landlord or electrician.

sks HTV4600 Specifications

General

Brand	sks
Model	HTV4600
Category	Intercom System
Language	English