Skyjack SJ12 Operating Manual

Section 2 - Familiarization Function Tests
It is the responsibility of the operator to read, completely understand and follow all instructions and warnings
contained in this operating manual and on the aerial platform.
FAMILIARIZATIONFAMILIARIZATION
• Test Pothole Sensor
WARNING
Ensure that you maintain three points
of contact to mount/dismount platform.
1. Dismount from platform and place a block,
approximately 1.5” (3.75 cm), under one
side of the pothole protection device.
2. Open the gate (if equipped) and access the
platform.
3. Close the gate (if equipped).
4. Raise the platform until approximately a
height of 2 feet is reached and attempt to
drive forward or reverse.
Result: Aerial platform should not move
forward or backward.
5. Repeat the steps above with block placed
under the other-side of the pothole
protection device.
Result: Aerial platform should not move
forward or backward.
• Test Lowering Only Alarm
WARNING
Be aware of overhead obstructions
or other possible hazards around the
MEWP when lifting.
1. Ensure path of intended motion is clear.
2. Lift and lower the platform.
Result: Alarm should sound while platform
is lowering.
NOTE
On MEWP with certain options, a flashing amber
light will accompany this alarm.
2.4-5 Optional Equipment/Attachments
• Test Flashing Light (If Equipped)
1. Ensure path of intended motion is clear.
2. Activate any drive or lift functions.
Result: Light should flash.
3. Stop all platform motion.
Result: Light should stop flashing.
Flashing Light
(If Equipped)
Pothole
Protection Device
Vertical Mast
Page 29
TM

Skyjack SJ12 Specifications

General

Gradeability	25%
Drive Motor	24V DC
Machine Width	32 in (0.81 m)
Stowed Height	6.5 ft
Overall Width	32 in (0.81 m)
Stowed Height (Rails Folded)	6.5 ft
Drive Speed (Elevated)	0.5 mph (0.8 km/h)
Power Source	Electric