SJ40 T+, SJ45 T+, SJ61 T+, SJ66 T+ 213201ACA
45
Visual and daily maintenance inspections Section 4 – Inspections Before Operation
4.2-6 Control compartment
Do the inspection that follows:
Make sure all compartment latches are latched tightly
and in good condition.
1
Base control console
▪
Make sure there are no loose or missing parts.
▪
Make sure there is no visible damage, and all
the switches are in their off/neutral positions.
2
Hydraulic tank
▪
Make sure the hydraulic filler cap closes
tightly.
▪
Make sure there is no visible damage or
hydraulic leaks.
Hydraulic oil level:
▪
Make sure the boom is in the stowed position.
▪
Do a check on the gauge on the side of the
hydraulic oil tank. The hydraulic oil level must
be at or a small distance above the top mark
of the gauge. Add oil if it is necessary. Refer to
the service manual for the recommended oil
type.
3
Hydraulic return filter
▪
Make sure the filter element is attached and
tight.
▪
Make sure there is no visible damage or
hydraulic leaks.
4
Manifolds
▪
Make sure all fittings and hoses are correctly
tightened.
▪
Make sure there is no indication of hydraulic
leakage.
▪
Make sure there are no loose wires or missing
fasteners.
5
Emergency-power unit
▪
Make sure there are no loose or missing parts.
▪
Make sure there are no loose wires or missing
fasteners.
▪
Make sure there is no visible damage.
▪
Make sure all the fittings and hoses are
correctly tightened and there are no hydraulic
leaks.
6
Fuel tank
WARNING
Explosion or fire hazard. Do not smoke near the
fuel system. If you do not obey, there is a risk of
death or serious injury.
IMPORTANT
Before you use the MEWP, make sure there is
sufficient fuel for the estimated task.
▪
Make sure that the fuel filler cap closes tightly.
▪
Make sure there is no visible damage to the
tank, gauge, hoses, or fittings.
1
2
43
65
To Next Page
Loading...
