213201ACA SJ40 T+, SJ45 T+, SJ61 T+, SJ66 T+
70
Section 5 – Operation MEWP shutdown
5.21 MEWP shutdown
1. Select a reasonably well-protected location to
park the MEWP. This location must have a firm,
level surface, clear of obstructions, and traffic.
2. Fully retract the boom and lower the platform.
3. Push the emergency-stop button on the
platform control console.
4. Exit the platform.
5. Turn the off/base/platform key switch to the off
position and remove the key.
6. Push the emergency-stop button on the base
control console.
7. Turn the main power disconnect switch to the
off position.
8. If it is necessary, put a cover on the platform
control console to prevent damage to
the warning labels and controls in hostile
environments.
5.22 Generator (optional
equipment)
To start the generator:
1. Make sure the engine is on.
2. Turn the generator switch to the on position.
To restore normal operation:
3. Turn the generator switch to the off position.
5.23 Glazier Tray (optional
equipment)
The glazier tray attaches to the kickplate of the
platform. Refer to the glazier operation manual for the
correct operation and maintenance.
1. Turn the capacity derate switch, and check that
the capacity derate light turns on.
5.24 Pipe Rack (optional
equipment)
The pipe rack attaches to the top platform railings.
Refer to the pipe rack operation manual for the
correct operation and maintenance.
1. Turn the capacity derate switch, and check that
the capacity derate light turns on.
To Next Page
Loading...
