SJ40 T+, SJ45 T+, SJ61 T+, SJ66 T+ 213201ACA
79
Move the MEWP for transport Section 6 – Additional Procedures
6.6 Move the MEWP for
transport
When you drive a MEWP onto or remove it from a
transport vehicle, on a public road, give protection to
the person(s) involved. Protection can include:
▪
Warning cones
▪
Road signs and signaling devices
▪
Applicable personal protective equipment, such
as reflective clothing
▪
Flag personnel to warn other vehicles of the
MEWP and other related vehicles
▪
Other applicable control measures.
Obey all the national, state/provincial/territorial, and
local safety rules when you move the MEWP for
transport. Only qualified personnel with authorization
must drive the MEWP on to or remove it from a
transport vehicle.
Be sure the vehicle capacity and load equipment,
hoists, chains, straps, and other related items are
sufficient to withstand the maximum MEWP weight.
Park the transport vehicle on a level surface. Use
wheel chocks or blocks to prevent unintended vehicle
movement during this operation.
6.6-1 Lock the turret
1. Rotate the turret until the transportation lock
2
is in line over the of the lock points
3
on the
chassis.
2. Lift and turn the lock pin
1
and lower it into the
lock point on the chassis.
2 1 12
Figure 17 Turret transportation lock
3
3
Figure 18 Turret transportation lock points
To Next Page
Loading...
