Skyjack SJ40 T+ - Wheel;Tire assembly

SJ40 T+, SJ45 T+, SJ61 T+, SJ66 T+ 213201ACA
47
Visual and daily maintenance inspections Section 4 – Inspections Before Operation
6
Wheel/Tire assembly
▪
Do a check on all tire treads and sidewalls for
cuts, cracks, holes, and unusual wear.
▪
Do a check on each wheel for damage, and
cracked welds.
▪
Do a check on each lug nut for the correct
torque to make sure they are not loose.
▪
Make sure the wheels are correctly aligned
vertically and horizontally.
▪
Make sure there are no loose or missing parts.
▪
Make sure there is no visible damage.
Refer to Section 7.6 for wheel/tire specifications.
WARNING
Do not use tires other than the tires that Skyjack
specifies for this MEWP. Do not mix different types
of tires or use tires that are not in good condition.
Only replace the tires with the same types that are
approved by Skyjack. The use of other tires can
make the MEWP less stable. If you do not obey,
there is a risk of death or serious injury.
7
Turret rotation gear (location may vary)
▪
Make sure there are no loose or missing parts.
▪
Make sure there is no visible damage.
8
Rotary manifold (location may vary)
▪
Make sure all hoses are correctly tightened
and there is no sign of hydraulic leakage.
8
6
7