Skyjack SJ9664 RT - Ground Operation with Platform Console

69
SJ9233 RT, SJ9243 RT, SJ9253 RT, SJ9664 RT 221491AFA
Use the platform control console from the ground Section 6 – Additional Procedures
6.3 Use the platform control
console from the ground
CAUTION
The correct operator location is from the platform.
Only operate the MEWP from the ground in these
conditions;
▪
When you can’t operate the machine safely
from the platform,
▪
When you need to operate the machine for
maintenance.
WARNING
Operating the MEWP from the ground presents
additional risks to the operator and other parties.
Appropriate risk assessment must be carried out
before operating from this position. If you do not
obey, there is a risk of death or serious injury.
6.3-1 Disconnect and remove the
platform control console
1. Disconnect the platform control console cable
from the electrical plug under the platform.
WARNING
Fall Hazard. Use the three points of contact
principle when you use the MEWP ladder to enter
or exit the platform. If you do not obey, there is a
risk of death or serious injury.
2. Use the MEWP ladder to enter the platform.
3. Remove the control console mounting bracket
lock-pin
1
from the mounting bracket. Remove
the platform control console from the mounting
bracket.
4. Remove the control cable lock-pin from the
railing clamp. Remove the control cable from
the clamp.
1
5. Use the MEWP ladder to exit the platform.