81
SJ9233 RT, SJ9243 RT, SJ9253 RT, SJ9664 RT 221491AFA
Move the MEWP through a doorway Section 6 – Additional Procedures
12. Unfold the front-left extension guardrail and
install all the lock-pins.
13. Unfold the rear-left extension guardrail and
install all the lock-pins.
14. Remove the lock-pin from the rear-left mid-
rail. Swing the rear guardrail towards the right
extension guardrail. Install all the lock-pins.
15. Remove the lock-pin from the front-right mid-
rail. Swing the front guardrail towards the left
extension guardrail. Install all the lock-pins.
16. Mount the platform control console at the front
right of the platform and install all the lock-pins.
WARNING
Before you operate this MEWP, make sure that
the guardrail system does not have loose or
missing lock-pins. The guardrail system must be
in the vertical position. Lock all pins correctly. An
incorrectly locked guardrail can cause a fall, which
can result in death or serious injury.
6.8 Move the MEWP through a
doorway
WARNING
Only do this procedure on level ground. If you do
not obey, there is a risk of death or serious injury.
1. Make sure the height/width of the doorway is
sufficient to let the MEWP drive through.
2. Before you operate the MEWP, do a full
inspection of the site (refer to Section 2.4).
Identify hazards in your work area.
3. Make sure the platform is fully lowered.
4. Follow Section 6.3-1 to disconnect and remove
the platform control console.
5. Fold the guardrails if it is necessary. Refer to
Section 6.7 for the procedure on how to fold the
guardrails.
WARNING
Crush hazard. Make sure that there are no
personnel in the path you will travel. Tell personnel
around the path before you move the MEWP. Use
a second person to monitor the movement of
the MEWP. Make sure that person stays at a safe
distance. If you do not obey, there is a risk of death
or serious injury.
6. Connect the platform control console cable to
the electrical plug at the rear side of the MEWP.
7. Stay behind the MEWP.
8. Make sure the platform control console points
in the same direction as the front of the MEWP.
9. Turn the main power disconnect switch to the
on position.
10. Pull the emergency-stop button on the base
control console.
11. Turn the off/base/platform key switch to the
platform position.
12. Pull the emergency-stop button on the platform
control console.
13. Start the engine. Refer to Figure 07.
14. Move the inclined drive/level drive switch
to the inclined drive (low speed/high torque)
position for reduced speed.
15. Move the lift/off/drive switch to the drive
position.
To Next Page
Loading...
