82
221491AFA SJ9233 RT, SJ9243 RT, SJ9253 RT, SJ9664 RT
Section 6 – Additional Procedures Move the MEWP through a doorway
16. Use as low a speed as practical to drive the
MEWP forward drive forward through the
doorway.
17. Push the emergency-stop button when the
MEWP is safely through the doorway.
18. Turn the main power disconnect switch to the
off position.
19. Disconnect the platform control console from
the rear side of the base.
WARNING
Fall Hazard. Use the three points of contact
principle when you use the MEWP ladder to enter
or exit the platform. If you do not obey, there is a
risk of death or serious injury.
20. Use the MEWP ladder to enter the platform.
WARNING
Before you operate this MEWP, make sure that
the guardrail system does not have loose or
missing lock-pins. The guardrail system must be
in the vertical position. Lock all pins correctly. An
incorrectly locked guardrail can cause a fall, which
can result in death or serious injury.
21. Return the guardrails to the vertical position if
folded. Refer to Section 6.7 for the procedure on
how to fold the guardrails.
WARNING
Fall hazard. Make sure each lock-pin is correctly
installed with the detent ball of each lock-pin fully
through the hole. Failure to avoid this hazard could
result in death or serious injury.
22. Put the platform control console back onto
the mounting bracket. Install the lock-pin in the
mounting bracket.
23. Put the control cable into the railing clamp and
install the lock-pin.
WARNING
Fall Hazard. Use the three points of contact
principle when you use the MEWP ladder to enter
or exit the platform. If you do not obey, there is a
risk of death or serious injury.
24. Use the MEWP ladder to exit the platform.
25. Connect the platform control console cable to
the electrical connector below the platform.
To Next Page
Loading...
