SkyLink EQ SERIES User Manual

Remote Control
To activate the opener with remote control, hold down the
button until the door starts to move. When the button is
press, the light indicator on the remote will flash. For remote
with multiple buttons, ensure to press the button that is
programmed to the desired opener.
Wall Button
Press the push button or the large button on the wall
console to activate the garage door opener.
On the Wall Console, there are 2 additional features:
1) Light Feature
2) Lock Feature
The light button can be used to turn the opener light on or
off. The automatic timer is ignored meaning the light will
remain on until the button is pressed again.
The lock button (also known as Vacation Button) can be
used to lock out all remote control transmitters. The door
can still be activated by wall control panel. Simply slide the
switch to the locked position , the opener will ignore all
the radio signals. To unlock, slide the switch to the
unlocked position .
Battery Replacement
All remotes come with battery installed. To replace the battery,
follow the instructions below.
OPERATION
12 volt alkaline battery
(size 23A) included.
12 volt alkaline battery (size 23A)
(included).
It is time to change the battery when
the red LED on the transmitter does
not turn on when either button is
pressed.
To prevent possible serious injury or death:
- Never allow small children near batteries
- If battery is swallowed, immediately notify doctor.
Push Button
Large Button
Light Lock
SK
Y
LI
N
K
SK
Y
LI
N
K
S
K
Y
L
I
N
K
S
K
Y
L
I
N
K
Visor Clip - Install the visor clip
to the remote as shown.
-23-
WARNINGWARNING

SkyLink EQ SERIES Specifications

General

Brand	SkyLink
Model	EQ SERIES
Category	Garage Door Opener
Language	English