PROGRAMMING
MAINTENANCE
Program Remote Controls
Follow the procedures below to program additional remote
controls.
1) Press the "Learn" button, yellow LED will flash for 30
seconds
2) Within 30 seconds, press the button on the remote that
you would like to program to the opener
3) Once the button is programmed, the yellow LED will be off
Erase All Remote Controls from Opener
To erase any unwanted remote, first erase all remotes.
1) Press and hold the "Set" button for 10 seconds, until the
yellow LED stays on steadily.
2) Release the "Set" button to complete the operation.
You have now erased all the programmed remote controls.
Reprogram each remote you wish to use.
Note: While pressing and holding the "Set" button, the
yellow LED and the red LED will flash. Do not release the
button until the yellow LED is steadily on.
Once a Month
- Test the door balance. Manually operate door. If it is
unbalanced or binding, call a trained door systems
technician
- Check to be sure door opens and closes fully. Adjust limits
and / or force if necessary
- Test the Safety Beam Sensor System and Safety Reversal
Test
Once Every Six Months
- Check the Chain Tension. Turnbuckle should be slightly
above the rail. Refers to page 7 to adjust the chain
tension.
Once a Year
- Oil the door rollers, bearings and hinges.
Up
Down
Learn/set
Wall Button
Safety Beam
Backup Battery
Power Travel Learn
Learn and Set Button
LED (yellow)
LED (red)
-25-
To Next Page
Loading...
Need help?
General
