Single action(MIST)
When the vehicle is powered
on, turn the wiper switch to
single action (1position in the
figure), and the BCM drives the
wiper motor to move at low
speed (45r/min) once.
Intermittent low speed mode
(INT for low configuration)
When the wiper switch is
turned to INT, BCM activates
the intermittent wiper mode
and drives the wiper motor to
work intermittently. The wiper
sensitivity switch has 5 blocks,
which are 2s, 4s, 6s, 8s, 13s
from top to bottom, and the
wiper works at low speed
according to different
intermittent
times.
Stop mode(OFF)
When the wiper switch is
turned OFF (2position in the
figure), the wiper will return to
the stop position.
Automatic mode (AUTO)
When the wiper switch is set to
AUTO (3position shown in the
figure), BCM will control the
wiper speed according to the
amount of rain.
Low speed mode (LO)
When the wiper switch is
turned to LO (4position shown
in the figure), the BCM drives
the wiper motor to act at low
speed (45r/min).
High speed mode (HI)
When the wiper switch is set to
To Next Page
Loading...