for the vehicle's maximum
deceleration in the shortest
time, thereby obtaining the
shortest braking distance.
Warning：
HBA can improve driving
safety, but cannot exceed the
laws of kinematics. Please
adjust the speed according to
the road conditions and traffic
regulations.
Hill-start hold control(HHC)
When the vehicle starts on a
slope with an angle greater
than 4%, the driver moves his
foot from brake pedal to the
accelerator pedal for a period
of time, HHC will appropriately
apply brake pressure to keep
the vehicle stationary and
prevent the vehicle from
slipping backward.
Warm reminders:
1. When the vehicle is uphill,
HHC can prevent the driver
from slipping behind after
releasing the brake pedal.
2. The driver can have up to
1.5 seconds to move his
foot from brake pedal to
PEDAL ASM
BRK&ACCEL&CLU to start
on the ramp.
3. If the vehicle skids during
HHC operation, the brake
pressure will be released
immediately to ensure the
maneuverability of the
vehicle.
4. HHC only applies brake
pressure appropriately, and
does not perform active
boost.
Caution：
HHC can provide auxiliary
braking pressure, but it cannot
exceed the law of kinematics.
For safety reasons, the driver
should apply the brake in time
according to the actual
situation of the vehicle to avoid
accidents caused by the
vehicle slipping backward.
To Next Page
Loading...