Option 2: Brew
Temperature
• Brew tank temperature setting, measured in real-time at
each grouphead and displayed in degrees Fahrenheit or
Celsius, depending on saved preference.
• Minimum setting: 82° C (180° F)
Maximum setting: 97° C (206° F)
Adjustable in tenth-degree (0.1-degree) increments
To adjust the brew temperature, see instructions under
Using Slayer
> Adjust Brew Tank Temperature on page
#28.
• Steam tank pressure setting, measured and
displayed in bar units
• Minimum setting: 0.8 bar
Maximum setting: 1.7 bar
Adjustable in tenth-bar (0.1-bar)
increments
Option 3: Steam Tank Pressure
To adjust the steam tank pressure, see instructions under
Using Slayer > Adjust Steam Tank Pressure on page #28.
Option 4: Hot Water Dose
• Hot water dose timer setting, measured and
displayed in seconds
• Minimum setting: 0.0 seconds (off)
Maximum setting: 20.0 seconds Adjustable
in tenth-second (0.1-second) increments
To adjust the hot water dose, see instructions under Using Slayer
> Adjust Hot Water Dose on page
#29.
Option 5: Automatic Group Cleaning Program
• Fast Clean
• Group Clean
To initiate the group cleaning program, see instructions under
Cleaning & Preventative Maintenance > Backflush the Groupheads
on page #35.
ADVANCED MENU
The second level of navigation is the Advanced Menu, which
contains the options listed below. While navigating the Barista
Menu, access the Advanced Menu at any time by pressing in the
jog wheel and holding for five (5) seconds.
Do not interact with the Advanced Menu before reading this
manual in its entirety. Then – if unsure – consult your Slayer
representative, reseller, or qualified service personnel.
Advanced Option 1: Heater Control Element On/Off
• Heating element controls for brew tanks, steam tank,
and vaporizer
• Unit of temperature measurement setting: Celsius
(C) or Fahrenheit (F)
To adjust the heater controls, see instructions under Using
Slayer > Other Menu Actions on page #30.
Advanced Option 2: Temperature Choose C or F
To adjust the unit of temperature measurement, see instructions
under Using Slayer > Other Menu Actions on page #30.
Advanced Option 3: Language
• Choose between English & Italian
To adjust the language, see instructions under Using Slayer >
Other Menu Actions> Change Language on page #32.
Advanced Option 4: Shot Lights Adj. Brightness
• Brightness setting for shot lights, represented with a
percentage value relative to maximum brightness
• Minimum setting: 0% (off)
• Maximum setting: 100%
Adjustable in .01 increments
To adjust the shot lights setting, see instructions under Using
Slayer > Other Menu Actions on page #30.
22
SLAYER STEAM X USER MANUAL V1.1 | SEPTEMBER 2019
To Next Page
Loading...
Need help?
General
