10
TIGHTENING THE BUNGEE
NO TOOLS NEEDED
1. Lock the Slider and stand it up.
2. Take one bungee clip off of the axle.
3. Pull bungee towards the larger opening in the keyhole to
loosen (or ‘unlock’). Pull 2 inches through, then tighten
towards the narrow keyhole to lock into place. Clip back on
bottom pulley axle (flat side to machine body).
Repeat steps for opposite side.
Make sure both clips are back on the axle.
Slowly lower machine, unlock the plate and row.
If it still feels loose repeat above steps.
4. You may need to cut off any excess bungee. If the
bungee appears frayed or does not give ample tension
after tightening, it is time to replace your bungee.
2. pull through
two inches
3. lock into place
1. pull down to unlock
To Next Page
Loading...