11
REPLACING THE BUNGEE
TOOLS NEEDED:
3MM ALLEN WRENCH
4MM ALLEN WRENCH
1. Lock the machine.
2. Take the 6 bolts off the front cover off using 3mm
Allen wrench. Take the black cap off using a 4mm
Allen wrench.
3. Stand machine up.
4. Take note of how the bungees are wrapped and parallel
(not crossed) before taking out old bungee.
5. Unhook bungees, unlock and slide out of hooks.
6. Insert the new bungee in bungee block.
7. Pull tight and line up.
8. Take right bungee piece and tie off on foot straps.
(cont. on next page)
To Next Page
Loading...