SMA EV Charger 7.4 - Page 16

4 Product Overview
SMA Solar Technology AG
Operating manualEVCxx-10-BE-en-1016
LED signal Explanation
The green LED is glowing Charge mode
The EV Charger charges the vehicle at more than 90% of its nominal
power.
The green LED is pulsing Charge mode
The EV Charger is equipped with a dynamic power display via the
green LED. Depending on the power, the green LED pulses fast or
slow.
The green LED is off The EV Charger does not perform any charging process.
The red LED is glowing Event occurred
If an event occurs, a distinct event message and the corresponding
event number will be displayed in addition on the product user inter-
face or in the communication product (e.g. SunnyHomeManager).
Red LED flashing Charging mode was interrupted by vehicle.
If this event occurs, the vehicle has interrupted the charging process.
Corrective measures:
• Opening and closing of the vehicle by radio remote control.
• Remove the charging cable from the vehicle and then
reconnect the charging cable to the vehicle.
• Check and if necessary adjust the settings in the vehicle's user
interface.
The blue LED flashes slowly
for approx. 1 minute
Communication connection is being established
The product is establishing a connection to a local network or is es-
tablishing a direct connection to an end device via Ethernet (e.g.
computer, tablet PC or smartphone).
The blue LED flashes quickly
for approx. two minutes
(0.25s on and 0.25s off).
WPS active
The WPS function is active.
The blue LED is glowing Communication active
There is an active connection with a local network or there is a di-
rect connection with an end device via Ethernet (e.g. computer,
tablet PC or smartphone).
All 3 LEDs light up and go
out after about 90 seconds
Start phase of charging operation
When the LEDs are off again, the start phase is complete and charg-
ing begins.