SMA EV Charger 7.4 - Activating WPS Function; Changing User Password

8 Operation
SMA Solar Technology AG
Operating manualEVCxx-10-BE-en-1042
Position Designation Description
F Monitoring Displays depending on the selected device the following
information on the current level and the superior levels:
• Energy and power
• Instantaneous values
• Status list
• Event monitor
G Dashboard Displays instantaneous values of the device currently se-
lected
H Home Opens the user interface homepage
8.3 Activate WPS Function
The WPS function can be used for different purposes:
• Automatic connection to a network (e.g. via router)
• Direct connection between the product and an end device
Depending on the intended application of the WPS function, the procedure for activation will vary.
Activating WPS function for automatic connection to a network
Requirements:
☐ WLAN must be activated in the product.
☐ WPS must be activated on the router.
Procedure:
1. Open the user interface (see Section8.1, page38).
2. Log into the user interface.
3. Select the menu item Network configuration in the menu Configuration.
4. Click on the button Use WPS in the Wi-Fi section.
5. Click on Save.
☑ The WPS function is activated and the automatic connection to the network can be
established.
Activating the WPS function for direct connection to the end device.
• Enable WPS function on the product. To do this, tap on the enclosure lid of the product twice.
☑ The blue LED flashes quickly for approx. 2 minutes. The WPS function is active during this
time.
8.4 Changing the Password
The password for the currently logged in user can be changed in the user interface of the product.
Procedure:
1. Open the user interface (see Section8.1, page38).