SMA EV Charger 7.4 - Mounting the Product

5 Mounting
SMA Solar Technology AG
Operating manualEVCxx-10-BE-en-1022
200
100
100
50
Figure 8: Recommended clearances(Dimensions in mm)
5.2 Mounting the product
Additionally required material (not included in the scope of delivery):
• 3 stainless steel hexagon head wood screws (AF10, diameter 6mm), screw length must be
suitable for the support surface and the weight of the product (fastening bracket thickness:
4mm)
• 1 washer (diameter: 6mm)
• Where necessary, 3 screw anchors suitable for the support surface and the screws
CAUTION
Risk of injury due to weight of product
Injuries may result if the product is lifted incorrectly or dropped while being transported or
mounted.
• Wear suitable personal protective equipment for all work on the product.
Procedure:
1.
CAUTION
Risk of injury due to damaged cables
There may be power cables or other supply lines (e.g. gas or water) routed in the wall.
• Ensure that no lines are laid in the wall which could be damaged when drilling holes.
2. Mark the position of the drill holes. Align the markings horizontally.
3. Drill the holes.
4. Insert screw anchors into the drill holes if the support surface requires them.