SMA EV Charger 7.4 - Receiving a Replacement Device; Replacement Procedure

13 Procedure for Receiving a Replacement Device
SMA Solar Technology AG
Operating manualEVCxx-10-BE-en-1058
13 Procedure for Receiving a Replacement Device
Under fault conditions, the product may need to be replaced. If this is the case, you will receive a
replacement device from SMA Solar Technology AG. If you received a replacement device,
replace the defective product with the replacement device as described below.
Procedure:
1. Decommission the defective product (see Section12, page54).
2. Mount the replacement device and make the electrical connections as described in this
document.
3. If the enclosure lid of the replacement device is a transport lid (see information on the
enclosure lid), replace the transport lid of the replacement device with the enclosure lid of the
defective product:
• Loosen all screws of the upper enclosure lid (TX25) and remove it.
• Replace the enclosure lid and tighten the
screws in the sequence shown (TX25, torque:
6Nm ± 0.3Nm). Finally, retighten the first
screw.
4x
2
3
4
1
4. Commission the replacement device (see Section7.2, page34).
5. Establish a connection to the user interface (see Section8.1, page38).
6. Configure the product using the commission assistant (see Section7.4, page36).
7. If the defective product had been registered by a communication product, replace it with the
new product in the communication product (see operating manual of communication product).
8. Pack the defective product in the packaging of the replacement device and arrange with SMA
Solar Technology AG for it to be picked up.