SMA EV Charger 7.4 - Page 35

7 Commissioning
SMA Solar Technology AG
Operating manual EVCxx-10-BE-en-10 35
2. Tighten the screws in the order shown (TX25,
torque: 6Nm ± 0.3Nm). Finally, retighten the first
screw.
4x
2
3
4
1
3. Tighten the 3 screws of the terminal cover in the
specified sequence (TX20, torque: 3.5Nm).
1
2
3
4. Wrap the charging cable around the enclosure.
5. Close unused enclosure openings with cable glands.
6. Ensure that all cable glands have seal inserts and that the seal inserts have not moved.
7. Switch on the AC circuit breaker.
8. Wait until the product is in charging mode. The procedure takes approx. 4 minutes.
Meanwhile, the current operating state of the product is indicated by the LEDs (see
Section4.4, page15).
9. In fast charging mode, perform the test of the charging station according to IEC 61851 and fill
in the test report. An example of a test report can be found at www.SMA-Solar.com.
10. If necessary, rectify any defects found.