SMA SUNNY BOY 4000-US - 6 Cleaning and Care; 6.1 Checking the Inverter; 6.2 Checking the DC Disconnect

SMA America, LLC Mounting
Installation Guide SB30-40US-IUS103030 31
2. Place a level on the top edge of the bracket. Adjust the position until it is leveled. The bottom of
the bracket will be the approximate location of the bottom of the inverter.
3. Use the wall-mounting bracket as a template. Mark the wall through at least three holes in
horizontal or vertical position of the bracket (see chapter 5.3.1”Possibilities for mounting the
wall mounting bracket” (page28)).
4. Remove the bracket, and drill holes at the marks.
5. Insert wall anchors into the drill holes.
6. Insert the screws through the holes in the wall mounting bracket and into the drill holes.
7. Tighten the screws clockwise until the bracket is held firmly against the wall. Do not overtighten
the screws.
☑ The wall mounting bracket is mounted.
DANGER
Risk of electric shock by drilling into power cables.
Death or serious injuries will occur.
• Before drilling, check installation location for power cables.
CAUTION
Falling of the Sunny Boy may cause injuries.
Crushing of body parts will occur.
• Ensure that there are studs in the wall where you intend to drill holes.
•Do not use molly or toggle bolts to mount the Sunny Boy to sheet rock or panelling.