Smalvic FI-95 E - Oven Door Glass Removal and Cleaning

40
Removing the glasses inside the oven door
This door model allows for extraction and cleaning of interior glasses without
having to remove the oven door. Follow the steps below to extract the internal
crystals:
 Open the oven door and immediately lock the hinges.
 There are two buttons on the left and right sides of the door, located on
the side profiles. Fig.1-A
 Press in order to release the painted top of the door and the two heads
placed on the profiles.
 At this point it is possible to extract the interior glasses with care. Fig. 1-B
Fig.1
ATTENTION! Always remember to lock the hinges before pulling the glasses. This
prevents the door from closing itself during the procedure.
Carry out the same steps in reverse order to refit the crystals. Take the utmost care
to ensure that they are in the right order and in the exact direction (the clear glass,
if present, must be inside the other two)
and the position of the writing on the glass surfaces should be lower left (whit the
oven door fully opened)
Be careful that the protective gaskets are positioned correctly. Before refitting the
door, make sure that the glass is securely fastened in place.
ATTENTION! Removal and installation must be carried out properly and with the
utmost care in order to avoid breaking the glass.