43
REPLACING THE OVEN LIGHT BULB
To prevent electric shocks and/or damage to persons, read and follow the
procedure given below:
WARNING: Ensure that the appliance is switched off before replacing the lamp to
avoid the possibility of electric shock.
Ensure that the oven and the light bulb are cold and then remove the protection
cover
A
Do not touch the hot bulb with a damp cloth as this may cause it to break.
Replace the light bulb with another suitable one of 25 W for 220 - 230 V with
attachment type E14 suitable for high temperatures.
In case the protection cover is damaged or broken, do not use the oven until the
cover has been replaced or re-inserted correctly and safely.
Attention: for correct installation and use of this appliance, refer to the technical
data given on the serial label of the product.
The product label is on the edge of the internal side of the oven. A second label is
positioned on the cover of the instructions manual.
INSTALLATION INSTRUCTIONS
The installation and technical assistance must only be performed by qualified staff.
Read the safety instructions given in this manual thoroughly before using the oven.
Incorrect installation, maintenance, assistance and use can cause serious
damage/injury to persons or objects.
This product must be installed as specified by this manual in compliance with the
National Standards and with the local regulations in force.
Do not lift or pull the oven from the door handle and do not exert pressure or load
weights when this is open.
The purchaser is responsible for installation. Assistance provided by the
manufacturing company due to an incorrect installation will not be included in the
warranty.
To Next Page
Loading...