Checking the drive belts
G
WARNING
Inadequately secured belt pulleys and
safety guards may become loose while the
ebike is in operation. Incorrectly aligned
drive belts may become detached from the
belt pulleys while the ebike is in opera-
tion. There is a risk of accident and injury.
R
Before every ride, check to make sure the
drive belt is properly aligned and ten-
sioned, and the belt pulleys are bolted
securely.
R
Also check for proper installation of the
slip guard to prevent the drive belt
jumping teeth or slipping.
Always follow all the instructions on han-
dling the drive belt – particularly every
time the rear wheel is removed or fitted
(Y page 59). Extra caution is required in
these cases in order to prevent damage to
the drive belt.
Checking the battery lock
Before every ride, make sure the locking
cylinder on the battery lock is engaged. If
the battery is not retained by the lock, it
could fall out while the ebike is in opera-
tion.
Checking the operation of the brake
system
Before every ride, carry out a stationary
brake test. To do so, pull the brake levers
towards the handlebar using two fingers
and normal braking force. The brake lever
must not come into contact with the han-
dlebar (Y page 24). A distance “A” must
remain between the brake lever and the
handle, even when maximum hand force is
applied.
Checking the brake system for wear
G
WARNING
After braking, particularly during long
descents, the brake discs and callipers as
well as the quick-release connections and
axle nuts may become extremely hot. There
is a risk of injury.
Wait until these components have cooled
down before touching them.
Check the brake pads for wear before every
ride (Y page 48).
Carry out a visual inspection of the brake
discs:
R
the friction disc must not show any signs
of scoring or breakout. It must be free of
oil and dirt.
R
All bolts must be present and securely in
place.
Check the brake callipers for oil leakage.
Make sure that the brake cables are free of
kinks. Check the brake cables for leaks.
Checking the bolted connections
Before every ride, check to make sure the
bolted connections listed below are
securely tightened:
X
check to make sure the quick-release
connector on the front wheel is securely
seated.
The word “CLOSE” must be visible on the
quick-release connector lever. It must
Inspection before starting a journey
19
>> Safety.
Z
To Next Page
Loading...