If a brake circuit has failed (Y page 160),
you must depress brake pedal : further
down to achieve the same effect and the
braking distance is increased.
i
The brake servo will only function with
the ignition switched on.
Switching off the drive system
G
WARNING
Do not turn off the drive system before the
vehicle has come to a complete stop. With
the drive system not running, there is no
power assistance for the brake and steering
systems. In this case, it is important to
keep in mind that a considerably higher
degree of effort is necessary to brake and
steer the vehicle.
X
Depress the brake pedal.
X
Move the gear selector lever to park
position P.
The transmission position indicator
should be on P
!
Always engage the parking brake in
addition to shifting to park position P.
X
Release the brake pedal.
X
Turn the key to starter switch position
0.
X
Remove the key from the starter switch.
The electronic immobilizer is
activated.
Transmission
Shifting procedure
Gearshift pattern for transmission
j
Park position
k
Reverse gear
i
Neutral position
h
Drive position
Select a gear:
X
Switch on the ignition.
X
Depress the brake pedal.
X
Move the gear selector lever to the
desired position.
Steering wheel paddle shifters (for
recuperation)*
G
WARNING
The operating condition of the high-
voltage battery (e.g. not yet at normal
operating temperature or fully charged)
influences the braking effect of the
electric motor.
In overrun or braking mode, the motor's
braking effect may therefore be reduced or
may not be present at all.
As a result of the reduced engine braking
effect, you may cause an accident and
injure yourself or others.
Transmission
77
>> Controls.
* optional
Z
To Next Page
Loading...
Need help?
General
