Control system
Introduction
The control system is activated when you
turn the key in the starter switch to
position 1.
G
WARNING
Adriver’s attention to the road and traffic
conditions must always be his/her primary
focus when driving.
In order to avoid distraction which could
lead to an accident, the driver should
select features and change settings in the
control system only vehicle at a standstill
or when traffic and road conditions permit
it to be done safely.
Bear in mind that at a speed of just 30 mph
(approximately 50 km/h ), your vehicle is
covering adistance of 44 feet
(approximately 14 m) every second.
Control lever
You can select the displays in the
multifunction display and change settings
in the control system with the control
lever.
:
Control switch
Pressing up selects a menu.
;
OK button
Confirming a selection.
Scrolling through stored messages
in the Messages
menu
=
Control switch
Pressing down selects a menu.
Multifunction display
The multifunction display shows values and
settings as well as display messages.
X
Activating the multifunction display:
Unlock the vehicle.
X
Confirming messages: Press the OK
button on the control lever briefly
(Y page 81).
X
Exiting menu: Press the control switch on
the control lever up or down until the
message Back
appears in the
multifunction display.
X
Press the OK button on the control lever
briefly.
Transmission position indicator
The transmission position indicator :
displays the current gear selector lever
position.
Display Function
P
Park position
R
Reverse gear
Control system
81
>> Controls.
Z
To Next Page
Loading...
Need help?
General
