SMARTEYE Netx Ethernet IP Control Unit User Manual Page 11
Filename: netx IP Platform User Manual R0 .doc
…
In Control
A
M
7.4.2 Multi-netx Jumper Block J2
Jumper Block J2 is located near the top midway between center and the right side of the Multi-
netx CPU/Reader interface board. This block is factory set with the top jumper installed and the
bottom jumper removed. These settings should not be altered.
7.4.3 Multi -netx Switches SW2 and SW6 – Not Used
Theses switches are either not used or set through software configuration only. Their settings on
the board are not recognized.
To Next Page
Loading...