SMARTEYE Netx Ethernet IP Control Unit Manual Page i
Filename: netx IP Platform User Manual R0 .doc
…
In Control
A
M
TABLE OF CONTENTS
1.0 Introduction........................................................................................................... 1
2.0 Smarteye Netx Control Unit Features ................................................................ 2
3.0 Smarteye Netx Product Installation.................................................................... 2
4.0 Power/Wiring ........................................................................................................ 2
4.1 Power/Wiring for Power over Ethernet 802.3af (48v) – S-netx and T-netx only...............3
4.2 Power/Wiring for T-netx Model SP4051/04-IP..................................................................3
4.3 Power/Wiring for Multi-netx Model SP4061/04-IP and SP4062/02-IP.............................3
5.0 Communication Line Wiring............................................................................... 3
6.0 Reader Wiring and Mounting ............................................................................. 4
6.1 Reader Wiring.....................................................................................................................4
6.2 Local Reader Mounting (S-netx only)................................................................................4
6.3 Remote Reader Mounting (S-netx, T-netx and Multi-netx) ...............................................4
7.0 Smarteye Netx Control Units CPU Configuration ............................................ 5
7.1 Configuration Legend.........................................................................................................5
7.2 S-netx Switch and Jumper Diagram....................................................................................6
7.2.1 S-netx Jumper Block J1 – Shield Termination Select............................................................. 7
7.2.2 S-netx Switches SW1 – Auxiliary Port Configuration........................................................... 7
7.2.3 S-netx Switches SW2, SW3, SW4, SW5 and SW6 – Not Used ............................................ 8
7.3 T-netx Switch and Jumper Diagram ...................................................................................8
7.3.1 T-netx Jumper Block J1 – Drain Termination........................................................................ 8
7.3.2 T-netx Jumper Block 2 ...........................................................................................................9
7.3.3 T-netx Switches SW2, SW3, SW4 and SW5 – Not Used ...................................................... 9
7.3.4 T-netx Power Select................................................................................................................ 9
7.4 Multi-netx Switch and Jumper Diagram...........................................................................10
7.4.1 Multi-netx Jumper Block J1 – Port Ground Select............................................................... 10
7.4.2 Multi-netx Jumper Block J2 ................................................................................................. 11
7.4.3 Multi -netx Switches SW2 and SW6 – Not Used................................................................. 11
7.5 Shield (Drain) Terminations (J1)......................................................................................12
8.0 Software Configuration...................................................................................... 12
8.1 Software Configuration Using the Network Port..............................................................13
8.1.1 Pre-Assignment of IP address............................................................................................... 14
8.1.2 DHCP Automatic Assignment of IP address........................................................................ 14
8.1.3 Manual Assignment of IP address Using Smarteye Netx Setup Utility Program................. 15
8.1.4 Manual Assignment of IP address using a Web Browser..................................................... 21
8.2 Software Configuration Using the Auxiliary Port ............................................................25
8.2.1 Serial configuration Commands ........................................................................................... 27
8.2.1.1 General Configuration Example.................................................................................. 27
8.2.1.2 Auxiliary Port Configuration Example ....................................................................... 28
To Next Page
Loading...