SMARTEYE T-netx - Auxiliary Port Configuration Example; SMARTEYE Netx Ethernet IP Control Unit Manual; Smarteye Netx Control Unit Configuration Parameters

SMARTEYE Netx Ethernet IP Control Unit User Manual Page 28
Filename: netx IP Platform User Manual R0 .doc
… In Control
A
M
?
DHCP: 1=No 2=Yes [2] ?
IP Address: [192.168.22.243] ?
Mask: [255.255.255.0] ?
Gateway IP: [192.168.22.1] ?
Time Server IP: [0.0.0.0] ?
Time Server Update Frequency: [60] ?
Time Zone (hours:minutes from GMT): [-5:00] ?
Date & Time: [10-MAY-2034 08:30:40] ?
Watchdog Enable: 1=No 2=Yes [2] ?
Password Protect: 1=No 2=Yes [1] ?
Diagnostic Start Delay ( tenths of seconds ): [5] ?
Diagnostic Finish Delay ( tenths of seconds ): [30] ?
Diagnostic Restart Delay ( tenths of seconds ) Zero to Disable: [0] ?
Network Fault Monitoring: 1=No 2=Yes [1] ?
Log E99 to History: 1=No 2=Yes [1] ?
Keep Alive Interval (0 secs = disabled): [0] ?
8.2.1.2 Auxiliary Port Configuration Example
COMMANDS:
1 = General Configuration
2 = Configure Auxiliary Port
d = Default Configuration
e = Erase Flash Configuration
s = Save and Restart
exit = Configuration and return to OS shell
conf % 4
Auxiliary Port Configuration
Baud Rate: 1=600 2=1200 3=2400 4=4800
5=9600 6=19200 7=38400 8=57600 [8] ?
Parity: 1=None 2=Odd [1] ?
Mode: 1=OS Console 2=Bluetooth Interface [1] ?
8.3 Smarteye Netx Control Unit Configuration Parameters
Configuration parameters can be set using the Utility program, a web browser, a telnet session or
through a serial connection to the auxiliary port. Refer to the “Software Configuration” section
starting on page 9.