Smartgen ALC700 SERIES User Manual

ALC700 Series Light Tower Set Controller
ALC700 Series Light Tower Set Controller 2018-03-02 Version 1.4 Page 34 of 51
Other parameters configuration (only configured by software via PC)
Parameters
Default
Start Delay
5s
Pre-heat Delay
0s
Cranking Time
5s
Crank Rest Time
10s
Safety On Delay
10s
Start Idle Time
10s
Warming Up Time
30s
Cooling Time
60s
Stop Idle Time
10s
ETS Solenoid Hold
20s
Fail to Stop Delay
30s
Over Speed Time
2s
Light Output Interval Time
2s
Total Number of Controlled
Light Tower
8
Audible Alarm Output Delay
30s
AC Generator Select
Yes
Poles
4
Magnetic Pickup
Yes
AC System
3 Phase 4 Wire
Fast Onload
No
Start Attempts
3
PT
No
Fuel Pump Control
No
Engine Temperature Sensor
VDO 120 degrees C
Oil Pressure Sensor
VDO 10 bar
Fuel Level Sensor
VDO ohm range (10-180)
Flexible Sensor
Not Used
Low Oil Pressure Shutdown
103Kpa
High Temperature
Shutdown
95°C
Low Fuel Level Warn
10%
Input Port 1
Remote start input
Input Port 2
Content: High Temperature;
Active Type: Closed to active;
Active Action: Shutdown;
Arming: From safety on
Input Port 3
Content: Low Fuel Level;
Active Type: Closed to active;
Active Action: Shutdown;
Arming: From safety on
Input Port 4
Content: Low Water Level;
Active Type: Closed to active;
Active Action: Warn;
Arming: Always
Output Port 1
Preheat during preheat timer; Normally open output

Smartgen ALC700 SERIES Specifications

General

Brand	Smartgen
Model	ALC700 SERIES
Category	Controller
Language	English