Smartgen HGM400 Series User Manual

HGM400 Series Genset Controller User Manual
HGM400 Series Genset Controller ISSUE 2015-05-27 Version 1.6 Page 15 of 44
14
Level Sensor
Open
When the controller detects that the level sensor is open
circuit and the action select “Warn”, it will initiate a warning
alarm and the corresponding alarm information will be
displayed on LCD.
15
Temp. Sensor
2 Open
If the config. sensor set as temperature sensor, When the
controller detects that the temperature sensor is open circuit
and the action select “Warn”, it will initiate a warning alarm
and the corresponding alarm information will be displayed on
LCD.
16
Oil Pressure
Sensor 2
Open
If the config. sensor set as oil pressure sensor, When the
controller detects that the oil pressure sensor is open circuit
and the action select “Warn”, it will initiate a warning alarm
and the corresponding alarm information will be displayed on
LCD.
17
Level Sensor 2
Open
If the config. sensor set as level sensor, When the controller
detects that the level sensor is open circuit and the action
select “Warn”, it will initiate a warning alarm and the
corresponding alarm information will be displayed on LCD.
18
High
Temperature 2
When the controller detects that config. sensor temperature
(sensor type: temperature sensor) has exceeded the pre-set
value while shutdown is prohibited, it will initiate a warning
alarm and the corresponding alarm information will be
displayed on LCD.
19
Low Oil
Pressure 2
When the controller detects that config. sensor oil pressure
(sensor type: oil pressure sensor) has fallen below the
pre-set value while shutdown is prohibited, it will initiate a
warning alarm and the corresponding alarm information will
be displayed on LCD.
20
Low Fuel Level
2
When the controller detects that config. sensor fuel level
(sensor type: level sensor) has fallen below the pre-set value
while shutdown is prohibited, it will initiate a warning alarm
and the corresponding alarm information will be displayed on
LCD.
21
Maintenance
Due
When genset running time has exceeded the user setting
maintenance time and the action select “Warn”, it will initiate
a warning alarm and the corresponding alarm information will
be displayed on LCD. The maintenance alarm will reset if the
action select “Inactive”.

Smartgen HGM400 Series Specifications

General

Brand	Smartgen
Model	HGM400 Series
Category	Controller
Language	English