am, all Auto Adjust watering
deficits are cleared and no
new deficits will accumulate.
The RUN MANUAL PRO-
GRAM button can still be
used to start a program. The
RED LED will be displayed
when controller is turned to
SYSTEM OFF.
If you move the dial to any
position other than RUN or
SYSTEM OFF, and there is no
control panel activity for 30
minutes; the controller will
return to the RUN mode, and
the display screen will show
the idle default screen or will
return to a program in
progress that was interrupted.
Mode Button: Used to select
Auto Adjust or Standard
watering. During normal
operation the MODE LED will
display GREEN. It will change to ORANGE during a pause in
operation and will display RED when SmartLine
®
controller dial
is turned to SYSTEM OFF.
Sensor Button: Used to activate or bypass optional sensors for
rain, freeze, or wind. If these sensors are connected to your
SmartLine
®
controller, they will override watering operations if
the ACTIVE LED is selected. If
your sensor/s have paused
your system operation, the
ACTIVE LED will be RED until
the sensor/s allow watering
to resume. In the event of a
“rain” pause, the LED will
change from RED to
ORANGE for 48 hours of
additional pause time before
the LED displays GREEN and
system operation resumes.
During a sensor pause, Auto
Adjust Watering deficits will
decrement to 0 at the rate of
1" per hour. The sensor LED
will display GREEN again
when the sensor/s are no
longer pausing your system
operation.
If you wish to deactivate the sensors, use the SENSOR button to
light the green BYPASS LED. Example: You wish to water after
fertilizing and your rain sensor is still pausing the watering pro-
gram. As long as the BYPASS LED is lit, the sensors will not
pause your system operation.
Getting acquainted with your Smartline
®
Controller 2.0
Note: No water-
ing will take
place when the
MODE LED is RED.
However, the SmartLine
®
controller will retain pro-
grams and current
date/time. An ORANGE
LED means watering is
paused temporarily due to:
run/soak, master valve
delay, zone to zone delay,
or omit hours. A program
in operation will also
pause if you turn the dial
to any position other than
RUN or SYSTEM OFF. The
program in operation will
resume (1) when you return
the dial to RUN or (2) if
there is no programming
activity for 30 minutes.
Note: The SEN-
SOR button can
be used to
bypass rain and freeze
sensors regardless of
whether your SmartLine
®
controller is in Standard or
Auto Adjust mode. The
bypass feature does NOT
override the SLW On-Site
Weather Station’s ability to
continue to provide data
to your SmartLine
®
con-
troller for Auto Adjust
operation. It can only be
used to bypass rain and
freeze pause functions.
4
To Next Page
Loading...
Need help?
General