Reset to Factory Settings
Each battery motor will come preprogramed from Smartwings .
The preprograming ensures the remote is paired with the motor, the upper and lower operation limits
are set, the remote is unlocked .
Follow the below steps to reset the motor to factory settings and delete all limits/remote pairings.
To reset the shade motor to factory settings with no stored limits locate the P1 button on the
motor head. Hold the programming button for 14 seconds. (the motor jogs four times)
The motor will jog 4 times before the reset is complete. The programming button must be held the
entire time. Red led light on confirm the factory reset is complete.
***Refer to the Initial Setup Programming section to program a shade after a factory reset.***
To Next Page
Loading...