C
ONFIGURING
THE
B
ARRICADE
4-6
Parameter Setting
Select your Country and Internet Service Provider. This will automatically
configure the Barricade with the correct Protocol, Encapsulation and
VPI/VCI settings for your ISP.
If your Country or Internet Service Provider is not listed you will need to
manually enter settings. Go to “Parameter Setting - Country or ISP Not
Listed” on page 4-9 in the manual.
If your ISP uses Protocols PPPoA or PPPoE you will need to enter the
username, password and DNS Server address supplied by your ISP.
If your ISP uses Protocol RFC1483 Routed you will need to enter the IP
address, Subnet Mask, Default Gateway and DNS Server address supplied
by your ISP.
Note: By default 192.168.2.1 is set for the DNS Server address, this
needs to be changed to reflect your ISP’s DNS address.
Click “NEXT” to continue.
To Next Page
Loading...
Need help?
General
