C
ONFIGURING
THE
B
ARRICADE
4-20
Remote Management
By default, management access is only available to users on your local
network. However, you can also manage the Barricade from a remote host
by entering the IP address of a remote computer on this screen. Check the
Enabled check box, and enter the IP address of the Host Address and TCP
Port Number. Click “SAVE SETTINGS”.
Note: If you check Enable and specify an IP address of 0.0.0.0, any
remote host can manage the Barricade.
For remote management via WAN IP address you need to connect using
Port Number 8080.
To Next Page
Loading...
Need help?
General
