8
S
YSTEM
C
ONFIGURATION
The SMCWEBT-G is a Plug-and-Play device. This means that, in
most cases, you will not need to configure it.
The latest firmware version may be downloaded from the SMC
web site specified on the back cover of this manual.
The SMCWEBT-G can be configured by a web browser,
specifically Internet Explorer 5.5 or above. Using the web
management interface, you can configure the Wireless AP and
view statistics to monitor network activity.
Before you attempt to log into the SMCWEBT-G’s web-based
administration, please verify the following.
1. Your browser is configured properly (see below).
2. Disable any firewall or security software that may be running.
3. Confirm that you have a good link LED where your computer
is plugged into the Wireless AP. If you don’t have a link light –
then try another cable to get a good link.
4. To access the Internet through the Wireless AP, you must
configure the network settings of the computers on your LAN
to use the same IP subnet as the Wireless AP. The default
network settings for the Wireless AP are:
SMCWEBT-G IP Address: 192.168.2.25
Subnet Mask: 255.255.255.0
To Next Page
Need help?
General
