H
OME
N
ETWORK
S
ETTINGS
27
Wireless
Operating Mode
This Wireless AP may be set to Access Point, Repeater, or
Ethernet Client (Infrastructure, Ad Hoc). (Default: Access Point)
Notes: 1. After you choose the operation mode for the
SMCWEBT-G, be sure to click the SAVE SETTINGS
button to enable the new setting.
2. The Wireless AP will automatically reboot enabling
your new settings.
These modes are described below:
• Access Point – If the SMCWEBT-G is in Access Point mode,
you must specify a common radio channel and SSID (Service
Set ID) to be used by the Wireless AP and all of your wireless
clients. Be sure you configure all of your clients to the same
values.
To Next Page
Loading...
