I
NSTALLING
THE
S
WITCH
3-4
receptacle located at the back of the device.
Figure 3-2. Power Receptacle
2. Plug the other end of the cable into a grounded, 3-pin socket.
Note: For International use, you may need to change the AC line cord.
You must use a line cord set that has been approved for the
receptacle type in your country.
3. Check the front-panel LEDs as the device is powered on to be sure
the Power LED is lit. If not, check that the power cable is correctly
plugged in.
AC 100V
-240V
50-60Hz
To Next Page
Loading...
